Loading cart items…
Subtotal—
Total—
🌍 Worldwide shipping · Express and Economy Options More information.
Take Your Stick to the Water
The Stick float kit converts your Stick 800 mm for takeoffs and landings on calm water.
We print each part with Regular PLA. The lightweight design helps preserve the model’s balance and stable flight characteristics.
Lightweight Float Kit ⚖️
Weight is critical on the 800 mm model. The complete float set weighs approximately 62 grams 🪶. For the best performance, keep the model’s total flight weight below 520 grams, including the floats.
Also, apply only the necessary amount of adhesive, primer, and paint. Extra weight can increase the takeoff distance and affect flight performance.
For your first float-equipped RC model, you may prefer the larger Stick 1000 mm version because it provides a more forgiving platform.
Easy Installation
The floats replace the original landing gear and use the model’s existing mounting system.
Therefore, you can switch between floats and standard landing gear without making permanent changes to the fuselage.
Assembly and Waterproofing 💧
3D-printed parts may contain microscopic gaps. Therefore, you must seal the floats before using them on water.
During assembly:
- Apply CA adhesive along every joint
- Spread the adhesive around each joint
- Check for visible gaps
- Avoid using unnecessary adhesive
After assembly:
- Apply one thin primer coat
- Apply one thin final paint or waterproof coating
You can use acrylic paint or another lightweight waterproof coating. However, avoid thick layers because they add unnecessary weight.
Finally, test both floats for leaks before installing them on the model.
Protecting the Electronics ⚠️
Water may enter the fuselage during takeoffs and landings. The Stick has drainage openings, so collected water can leave the model. However, these openings cannot protect the electronics.
Therefore, we strongly recommend waterproofing the Servos, Receiver, and ESC.
Keep the electronics as dry as possible. In addition, inspect the complete system after every water flight.
Key Features
- Designed for the Stick 800 mm
- Physical 3D-printed float kit
- Lightweight Regular PLA construction
- Replaces the standard landing gear
- Helps preserve the model’s balance
- Easy to install and remove
- Requires no permanent fuselage modification
- Paintable and customizable
Compatibility
This Stick float kit fits only the standard Stick 800 mm.
For the enlarged model, choose the separate Stick 1000 mm Float Kit.
Important Information
This product comes as an unassembled physical kit.
You must glue, seal, paint, and test the floats before use. The package does not include the model aircraft, electronics, adhesive, paint, waterproofing products, or digital files.
Use the model only on calm water. Also, inspect the floats, mounting points, electronics, controls, and drainage openings before every flight.
Turn your Stick into a water-ready RC model and discover a completely new flying experience
Additional information
| Weight | 200 g |
|---|---|
| Dimensions | 300 × 200 × 100 mm |
You must be logged in to post a review.
Reviews
There are no reviews yet.